HOW TO APPLY VINYL
PEELING BACKING PAPER
Lay the vinyl on a flat surface with the design facing up and squeegee over the whole design from the centre out. Then flip it over so the backing paper is now facing up, and squeegee again. Using a 45-degree angle slowly start peeling off from the corner of the backing paper.
If sections don't come off stop and watch the video.
DRY VINYL APPLICATION
Dry application is for all designs being applied onto walls, painted surfaces & wood, as well as metallic vinyl on all surfaces or for small, thin or delicate vinyl graphics.
​
For glass and metal: wet application is a must except for applying smaller stickers, delicate designs or individuals who have some experience in fitting adhesive graphics.
​
DO NOT use dry application with large matt & gloss designs going onto glass/metal or frosted vinyl as it will leave bubbles and will permanently damage the vinyl.
​
WET VINYL APPLICATION
Wet application has to be used for larger graphics & frosted vinyl whilst installing.
It will also reduce the possibility of bubbles with smaller reversed designs on glass.
​
For installing large or non-delicate vinyl graphics on windows, metal & plastic.
​
DO NOT use wet application on walls or wood, with metallic vinyl or when the design is very thin and delicate.
​
FROSTED VINYL APPLICATION
Frosted vinyl has to be applied wet and requires a helper, please watch the two videos attached, and refer to the pdf: Full instructions pdf on this link